| FABRIC SPECIFICATIONS |
| Weave |
Woven black HDPE scrim |
| Coating |
4.0 mil average each side (94 g/m2, each side) |
| Colour |
White/Black or other coloured coatings available |
| Weight |
12.0 oz/yd2 (407 g/m2) +/- 5% |
| Thickness |
20 mils (0.51 mm) ASTM D5199 |
| PERFORMANCE |
| Grab Tensile |
Warp 350 lb 1555 N |
Weft 330 lb 1467 N |
ASTM D5034-95 |
| Tongue Tear |
Warp 110 lb 490 N |
Weft 110 lb 490 N |
ASTM D2261-96 |
| Tongue Tear - Large Scale |
Warp 111 lb 497 N |
Weft 108 lb 480 N |
ASTM D5884-01 |
| Trapezoidal Tear |
Warp 90 lb 400 N |
Weft 95 lb 422 N |
ASTM D4533-04 |
| Mullen Burst |
650 psi 4485 kPa |
|
ASTM D3786-01 |
| Hydrostatic Resistance |
424 psi 2927 kPa |
|
ASTM D751-00 |
| Puncture Resistance |
182 lb 811 N |
|
ASTM D4833-00 |
| Dimensional Stability |
Warp -4.20% |
Weft -3.72% |
ASTM D1204-02 |
| Carbon Black Content |
4.77% wh intact |
2.96% wh removed |
ASTM D4218-96 |
| Volatiles |
0.13% |
|
ASTM D1203-94 |
| Low Temperature Flex |
Warp Pass@-40˚ |
Weft Pass@-40˚ |
ASTM D2136-94 |
| Accelerated UV Weathering1 |
>90 % strength retention after 2000 hrs exposure @ 0.77 W/m2/nm, or 1200 hours exposure @ 1.35 W/m2/nm. |
ASTM G151-00
ASTM G154-04 |
| Seam Strength (Shear) |
200 lb/inch (1780 N/5cm) |
ASTM D751-00 |
| Seam Strength (Peel) |
7 lb/inch (62 N/5cm) |
ASTM D4851-97 |
 |
| 1 Q.U.V. [A-340 Lamps}: 8 hrs UV @ 60˚ C; 4 hrs condensation @ 50˚ C |
|
| These values are typical data and are not intended as limiting specifications. |
|
| ROLL SPECIFICATIONS |
| Cores |
4 inch (101.6mm) or 5 inch (127 mm) I.D. |
|
| Width |
Up to 150 inches (-0, +0.5) as ordered, 3.81 m (-0,+12mm) |
| Length |
Minimum 250 yds/roll (229m); up to 1000yds/roll (914 m) |
|
| WARRANTY |
| A 5 year limited warranty is offered on liners used in exposed applications. On fully buried installations, the limited warranty is for a period of 10 years. Contact your IPG representative for further details. |
